***********************************************************************************
********************************************************************************
2012 Land Rover Range Rover (LM) V8-5.0L SC Page 1
Vehicle: All Technical Service Bulletins
Collision Avoidance - Surround Camera Image Lost
LTB00430NAS2
26 JULY 2012
ISSUE 2 CHANGES ARE HIGHLIGHTED IN GRAY AND ASTERISKS
SECTION: 418-02
Surround Camera System Camera Equalizers
AFFECTED VEHICLE RANGE:
CONDITION SUMMARY:
Situation:
On vehicles fitted with the Surround Camera System (not vehicles fitted with Parking Aid - Rear View Camera only), the camera image
may be lost and a blue screen is displayed.
Cause:
This may be caused by signal loss through the coax.
*NOTE: LR4 and Range Rover Sport vehicles experiencing a rear or front bumper camera blue screen concern and eligible for Service Action Q179, perform the Repair Procedure as described in Technical Bulletin Q179NAS.*
NOTE:
For Range Rover vehicles experiencing a rear camera blue screen concern and eligible for Service Action Q140, perform the Repair Procedure as described in Technical Bulletin Q140NAS. For vehicles experiencing an issue with a camera where an equalizer kit is not available, refer to Technical Bulletin LTB00367NAS for further information.
Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below to install an equalizer kit(s).
PARTS:
TOOLS:
Refer to Workshop Manual for any required special tools
WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.
2012 Land Rover Range Rover (LM) V8-5.0L SC Page 2
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal Warranty policies and procedures apply
REPAIR PROCEDURE
INSTALL NEW SURROUND CAMERA SYSTEM CAMERA EQUIALIZERS NOTE:
Do not replace all camera equalizers. Only install a camera equalizer to a circuit which is displaying no image / blue screen.
- Refer to Workshop Manual, section 418-02: Wiring Harnesses, and install new camera equalizers.
- Verify Surround Camera System camera operation:
^ If the image is lost or a blue screen is displayed, refer to Technical Bulletin LTB00367NAS for further information.
Disclaimer
