Emissions - Secondary Air Hose Tube Reassembly
TA02 1701
December 5, 2002
ATTENTION:
Service Manager
Service Advisor
Technician
V8 Vehicles with Secondary Air Injection
Discovery Series II and Range Rover 2000-2002
When performing engine-related repairs on a vehicle equipped with secondary air injection, the system pipes may need to be removed to facilitate
repairs. Warranty claims indicate that the these pipes are often being replaced unnecessarily.
Affected Components
^ Pipe secondary air injection
^ Adaptor SAI rail
Investigation shows that when the components are dismantled from the engine/vehicle without damage difficulty may be experienced when
reassembly of the removed pipe to the engine is attempted after repair. Exhaust heat from the engine has, over time, distorted the pipes very slightly.
Removal from the engine permits the pipes to move/expand to release the built-up stress.
The distortion makes it very difficult to quickly re-assembly the pipes back onto the adaptors without cross threading the union nuts fittings. Patience
and a little extra time are required. Refer to the RAVE WSM sections 17.25.17-18 and perform the following refined assembly process:
1. Carefully align the pipe and the pipe union nuts.
2. Start the pipe nuts by hand. (Figure 1)
CAUTION:
Damage to the fittings can occur if care is not exercised during the assembly process.
3. Tighten both union nuts completely finger tight BEFORE any tools are used.
4. Install air manifold bracket nuts and tighten.
5. Torque the pipe union nuts to 25 Nm (18 lbf.ft.)
